Hydrajaws M2000 MATERIAL BOND Tester Kit with 0-25kN/5620lbf (Digital or Analogue Gauge)


Check below for details.

Get a Quote

Please contact for a quote and availability, thanks!

Hydrajaws develop and manufacture a range of portable pull testers for testing the crucial holding force of anchors and fixings in construction materials.

Adequate direct tensile strength or bonding strength between two layers is important if repairs to concrete structures or additional overlays and screeding on existing concrete is to be structurally sound. The pull-off test as a means of projecting the compressive strength of concrete and other materials involves bonding a circular steel disc to the surface by means of an epoxy resin adhesive. A controlled tensile force is then applied to the disc, and as the strength of the bond is greater than that of the material under stress it will eventually fail in tension. From the area of the disc an the force applied at failure it is possible to calculate a nominal tensile strength for the material.
INCLUDED: 
  • M2000 tester with quick release female coupler and turning handle
  • 25kN Dual Scale Digital/Analogue Gauge with quick release male coupler
  • Oil Bottle with quick release male coupler

  • 2000 Piston key

  • Bond Stool bush

  • Bond Stool plate with 80mm legs

  • 10 x 50mm bond discs with machined scrolled surface

  • 10 x 75mm bond discs with machined scrolled surface

  • 22mm open ended ratchet spanner

  • 10mm open ended wrench

  • Allen Key 2.5mm

  • Allen key 6mm short

  • M2000 Instruction Manual

  • Red C120 Carry Case with foam inlay and generic lid inlay including document holder

  • Promotional Marketing Go Digital

  • Digital Gauge Instruction

  • Allen key 2mm

  • Spare Battery 9v (located under gauge)

  • Calibration Certificate